hi,
I try to get DASH3 configuration in dash3 configuration soft.
DASH3 is connected to a PC with a direct serial output.(not USB).
i select -> file-> read configuration from device.
i select the port, get file, and i get "can't detect the sequence".
i have never send any file to dash.
i want to see the default configuration file.
what can i do ?
thanks for your help,
jpm
DASH3 configuration ?
You cant just hook the dash3 to the PC. The Dash3 unit needs to be powered by 12v at pin 7 in the dsub. Either by the adapter from RaceTech or simply make an adapter where you connect +12v at pin 7 on the dash3 and GND at pin 5. It is very convenient to configure the unit directly from the PC instead of using the other procedure involving Flashcard and the DL1 since you can sit by your desk and see the results directly on the display.
Last edited by 2fast4u on Sat Sep 06, 2008 6:44 pm, edited 1 time in total.
a good way for support
please put an adaptater for pc in DASH3 kit........
Kit is a little shoort, but DASH3 look nice and very easy to use.
soft DASH3 is very useful, it is the only way to change easyly configuration, sometime it is the only way(RPM).
I hope you will do something quickly, you have a produce well create, make it perfect and you will get a lot of money !
thanks,
jpm F3 customer
Kit is a little shoort, but DASH3 look nice and very easy to use.
soft DASH3 is very useful, it is the only way to change easyly configuration, sometime it is the only way(RPM).
I hope you will do something quickly, you have a produce well create, make it perfect and you will get a lot of money !
thanks,
jpm F3 customer
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 231 guests