Hi ,
I have a Motec PDM15 installed in my race car . The PDM can transmit on CAN messages under "Global error" for overcurrent , circuit shut down , overtemp etc.
Is it possible, has anybody decoded these messages and interpret them ? i have a situation where power is shut down to ecu ,fuel pumps and followed by shut down to the DASH2pro while on track . I cant pin point the problem. it would be nice to log and be able to diag. grounds , B+, battery isolator have been either replaced, checked .Wonder if the Motec PDM goes into a total shut down if it detects an overload /short or it disables only the affected outputs.
The PDM does not have fault logging .
Adrian
Motec PDM CN messaging
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 3 guests