Hi everyone,
We need the PDF doc that describes the serial data format of the DL2's
serial data output (RS-232). This doc is not accessible from the website.
Please email it to : schoday@iit.edu
Please include the VB example too if you can.
Thank you
Serial data format needed URGENTLY
[Mode admin ON]
The serial data format is explained in the knowledge base pages, under software,main analysis software, technical,serial data format and the different subpages.
Exept the Channel 3 (raw GPS data), everything is explained in details. File format is the same, there is only 8 bytes at the beginning wich I don't have the definition.
[Mode admin OFF]
Angelo
The serial data format is explained in the knowledge base pages, under software,main analysis software, technical,serial data format and the different subpages.
Exept the Channel 3 (raw GPS data), everything is explained in details. File format is the same, there is only 8 bytes at the beginning wich I don't have the definition.
[Mode admin OFF]
Angelo
GPS raw decode pdf
Hello,
I want to test the dl1 as an standard serial GPS receiver and decode it into an FPGA board. Is it possible without decoding all the RT frames?
I'm also interested in the GPS format PDF file if possible.
Best regards.
Jean-Michel
I want to test the dl1 as an standard serial GPS receiver and decode it into an FPGA board. Is it possible without decoding all the RT frames?
I'm also interested in the GPS format PDF file if possible.
Best regards.
Jean-Michel
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 19 guests