I’m have a nightmare with setting up my dash atm, I’ve nearly had it a year and it’s still not fully working.
I’ve had most stuff working but some things still aren’t.
I have a emtron ecu and connecting to my dash via CAN
I can’t get my speedo, gear indicator and afr to work.
I want the Gear indicator and afr to run through CAN and speedo through a wheel speed sensor.
The wheel speed sensor was working ok on my last dash (dash2) until I upgraded to the pro.
I’ve noticed on my wheel sensor, the led light goes as it should without the signal wire connected but as some as I connect the signal wire it will only dim and not go out.
Can anyone help?
Dash2 pro set up
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 21 guests