Hi,
Is it possible to set the analysis software up to automatically load the required variable file like with the car options file?
If yes, how can I know the serial numbers of my DL1s? I have lost the sticks with the S/N
Thanks in advance
Variable information of two different cars
Well, Just now I know where to see the S/N of the logger in the analysis sw.
But my problem is: How can I compare for example wheel speeds from two different cars with different variable files?
What I do is: First I load the run of the first car and I load its variables and after that, I load the run of the second car with its variables and reprocess data.
The question is: If I reprocess all data when I load the second run, the first run is reprocessed with the variables of the second car? Isn't it?
I am not sure
But my problem is: How can I compare for example wheel speeds from two different cars with different variable files?
What I do is: First I load the run of the first car and I load its variables and after that, I load the run of the second car with its variables and reprocess data.
The question is: If I reprocess all data when I load the second run, the first run is reprocessed with the variables of the second car? Isn't it?
I am not sure
Its only possible to assign different vehicle files (.car) to each individual run. The variable information will always be the same.
It is however possible to assign constants to the vehicle file so you could have "User defined variables" call for different vehicle constants to correct the information or even use the car constants in the calibration equations.
It is however possible to assign constants to the vehicle file so you could have "User defined variables" call for different vehicle constants to correct the information or even use the car constants in the calibration equations.
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 212 guests