Hi,
I have a DASH2 and DL1 installed and connected via serial cable. I have the DASH2 setup to display a number of channels from the DL1, namely analog 1-7. These work satisfactorily. However I cannot get it to display DL1 analog channel #8 which is Battery Voltage.
I have configured the DASH2 using the Config Utility. I rename analog #8 from the DL1 "Batt" and upload it, however when connected all I get is
"T" and "00000" as values on the DASH2. I checked the DL1 using Lite Monitor and channel #8 is displaying Battery Voltage. For some reason the DASH2 is not reading this channel. Can anyone help?
Marck Carey
Problem getting battery voltage to show on DASH2
-
- Posts: 13
- Joined: Tue Dec 08, 2009 9:35 pm
- Location: nottingham
- Contact:
battery voltage display problem
Any answers please RT? I have the same issue
Re: battery voltage display problem
moleracing wrote:Any answers please RT? I have the same issue
I ended up having to use one of the DASH2 input channels. I applied battery voltage to it, and scaled it using y=1x.
-
- Posts: 13
- Joined: Tue Dec 08, 2009 9:35 pm
- Location: nottingham
- Contact:
-
- Posts: 13
- Joined: Tue Dec 08, 2009 9:35 pm
- Location: nottingham
- Contact:
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 188 guests