I have just downloaded the new version 7.3.96 and tried to use the lap simulation feature (I had not tried this before). However, after following the help section etc. cannot see any simulation variables. The help says this is still in development mode but should I be able to use it in this version?
Ray,
Simulation in Version 7.3.96
-
- Posts: 10
- Joined: Wed Jul 30, 2008 8:02 pm
- Location: Auckland, New Zealand
-
- Posts: 10
- Joined: Wed Jul 30, 2008 8:02 pm
- Location: Auckland, New Zealand
-
- Posts: 10
- Joined: Wed Jul 30, 2008 8:02 pm
- Location: Auckland, New Zealand
Version 7.3.119 is the latest Analysis Software version available on our website and I'm running that at the moment, this is the one that has the debugging variables mistake, if you download that one you should be able to see the SIM variables.
The Simulated time and simulated delta are always grayed out, this is to distinguish those from the real sector and lap times.
The Simulated time and simulated delta are always grayed out, this is to distinguish those from the real sector and lap times.
-
- Posts: 10
- Joined: Wed Jul 30, 2008 8:02 pm
- Location: Auckland, New Zealand
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 144 guests