RPM [5v] Connection
Posted: Fri Apr 25, 2008 5:56 pm
ok i got a Hall effect sensor that uses 4-30VDC and conected this to the 12VDC on car and the Signal wire to the RPM [5v] on back of the DL1 Logger my Dash two is configured to use RS232 for RPM but none are shown i connected the Live monitor software to check teh new hall effect sensor it showed 5100 is RPM when i revv the Car it increases accordingly i can Send the data i logged it but why oh why doesnt the Dash two show any information ive included i diagram of my Crank pully
AS you can see theres three Holes so it pulses 3 times in one rotation or is it 6 times.?? need help configureing the dash two to show the data and the DL1 to logg it correctly please
this is the 4th if not 5th post on this issue and am feeling a little offput
AS you can see theres three Holes so it pulses 3 times in one rotation or is it 6 times.?? need help configureing the dash two to show the data and the DL1 to logg it correctly please
this is the 4th if not 5th post on this issue and am feeling a little offput