The other option would be to use a laptop battery with a 12v voltage regulator.

Thanks for the update.

I'ts going to take me about 4 - 6 weeks to finish building the engine and installing etc.

So hopfully the new firm where will be out them.

If not will just have to fit a few duplicate sensor's

Anyone else getting this problem.

Leigh

Hi its direct to the Dash 2.

Ok thank you.

Keep me updated on what you find.

Are you useing both the dash and DL1

Even when using a fixed voltage test with a digital meter and a voltage regulator. The displayed setting will fluctuate a lot. I have to set the sample to 100 times to get a steady reading. Even at 10 samples it will fluctuate +-0.2 I put the latest flash on and its still doing it. It's a new unit. ...

If you use boiling water, unless you mesure it from a pan while its still boiling it will cool to about 80oC very quickly if poured into a container.

Only if you mesure from a boiling pan it will still only be about 96oC so use a digital thermonitor when you take you readings.

Best thing to do.
Is take the sensor out.

Connect to a foot pump. and connect a meter to the Sensor.
And take a reading at 0,1,2,3,4 and 5 bar.

Use Potential Divider Calculator http://www.electronics2000.co.uk/calc/calcdiv.htm

once you have the 6 voltages and Pressures you can enter these into the RT software.

Has anyone setup the DL1 and Dash2 with an Emerald ECU.

If so could you send me you Dat file, as should save me some time.

Thanks
Leigh

If you want to use the Lucas 73355 sensor which are very common. You can use the following settings +5v Ref Voltage, Fixed Resistance R2 1k Sensor V-out Resistance Volts Temp 9200 0.48 -10 oC 5800 0.71 0 oC 2500 1.39 20 oC 1200 2.22 40 oC 600 3.06 60 oC 360 3.60 80 oC 175 4.18 100 oC Potential Divid...

Can I have a copy of the latest flash for the Dash2.

I also notice the dash 2 now has a 5v Ref out. is this only for new units or will the latest flash enable this pin.

Thanks
Leigh