Hi, My PC is set to German but I want the RT programs to be English because I'm already used to the English terminology in the programs. All your documentation and knowledge base is available in English only so for me the English programs are easier to use... I don't know a way to set the language o...

With the latest version from today it changed to German. I want it back to Englisch.

Thanks,
Thomas

I think this has been answered in this thread:

http://www.race-technology.com/forum/viewtopic.php?t=1741

Best regards,
Thomas

Ok, thanks! Good to know.

Thomas

Hi all,

Can I leave the OBD-II connector from the CAN OBD interface permanently connected to the OBD-II port? Or is it drawing power even when the engine is not connected (if it is drawing power at all)?

Thanks,
Thomas

Hi, Thanks for the answer although this is no good news (I just saw in your knowledge base that you mention it and I must admit that I have read over this paragraph). Is it possible to speed up the updates by not requesting other data? I haven't used the CAN configuration yet. So would it be possibl...

I'm still testing: A new run of about the same length has "only" 14 data formatting errors. But this time there is no serial number of the logger displayed. Instead I get this in the Run Manager. "No logger serial number is available in the data stream." It seems that all OBD val...

Thanks!

Thomas

Hi, I'm a new owner of a DL1/DASH3 bundle + OBD CAN interface using it in a Lotus Elise S (2009). Since I have the OBD CAN interface connected I get data formatting errors in the Run Manager (e.g. 157 in a test run of appr. 10 minutes). No errors without the OBD CAN interface so far. I also noticed ...

Hi, I am wondering if the DL1 and DASH3 configuration files (SETUP.BIN and DASH.HEX) must be always available on the CF card if I want to use a configuration different from the factory defaults. Or is it ok to delete them from the CF card after the first usage of the hardware with these conf files? ...