Search found 2 matches

by justpete
Mon Jul 14, 2014 3:33 pm
Forum: General support questions
Topic: Configuring Dash3 from DL1 corrupting Dash2
Replies: 2
Views: 5438

Had a similar problem corrupting a DASH3 when updating with a .hex file on the card loaded into a DL1Mk3. But the problem was due to the OBDII serial cable's splitter. The manual for the DASH3 says it must be hooked up directly to the DL1 for the .hex file to work correctly and it did when I did so....
by justpete
Mon Jul 14, 2014 3:28 pm
Forum: General support questions
Topic: Config help DL1 MK3
Replies: 1
Views: 4524

Re: Config help DL1 MK3

I have a new DL1 MK3. When I read the current configuration, and make the needed changes to support my installation, sensors, ECU adapter and dash and then save the changes, I am greeted with a list of errors (6). I found two of the 1. Output drivers used but not enabled in the device This I unders...

Go to advanced search