Search found 6 matches

by justpete
Mon Jul 14, 2014 3:33 pm
Forum: General support questions
Topic: Configuring Dash3 from DL1 corrupting Dash2
Replies: 2
Views: 2155

Had a similar problem corrupting a DASH3 when updating with a .hex file on the card loaded into a DL1Mk3. But the problem was due to the OBDII serial cable's splitter. The manual for the DASH3 says it must be hooked up directly to the DL1 for the .hex file to work correctly and it did when I did so....
by justpete
Mon Jul 14, 2014 3:28 pm
Forum: General support questions
Topic: Config help DL1 MK3
Replies: 1
Views: 1983

Re: Config help DL1 MK3

I have a new DL1 MK3. When I read the current configuration, and make the needed changes to support my installation, sensors, ECU adapter and dash and then save the changes, I am greeted with a list of errors (6). I found two of the 1. Output drivers used but not enabled in the device This I unders...
by justpete
Tue Jul 08, 2014 2:41 pm
Forum: Pre-sales product questions
Topic: BMW E90 CAN messages
Replies: 4
Views: 5668

Is that not this one? m Martin Yep, that's it alright! So I'm a bit confused about how to use the table. I have a CAN license for 30 channels and CANbus setup for some other parameters. I've looked at the DL1 CAN input setup window and it _looks_ like each channel only needs to be enabled and mappe...
by justpete
Sun Jul 06, 2014 11:50 pm
Forum: Pre-sales product questions
Topic: BMW E90 CAN messages
Replies: 4
Views: 5668

OK, better way to phrase the question -- if the canbus port on a DL1 Mk3 is tied into the PT-CAN bus that the DME.ECU is on, etc. will the parameters given for the E46 be logged the same way? I'm assuming the address, bit, scaling, etc. is the same but no way to know. Any help would be greatly appre...
by justpete
Sun Jul 06, 2014 9:14 pm
Forum: Pre-sales product questions
Topic: BMW E90 CAN messages
Replies: 4
Views: 5668

BMW E90 CAN messages

Has a setup file like the one for the E46 -- http://www.race-technology.com/wiki/ind ... pe/BMWMINI -- been developed yet for the E9x chassis and MSV80 DME/ECU?
by justpete
Tue Apr 22, 2014 1:49 am
Forum: GPS-specific questions
Topic: Postprocess and 20Hz option
Replies: 1
Views: 2893

Postprocess and 20Hz option

I have the 20Hz option in a DL1 Mk3 but selecting any option under the GPS tab of the Analysis Option but the first one returns an error msg: This operation requires the purchase of the high accuracy 20hz gps add-on. To purchase licence keys, please contact www.Race-technology.Com. And then the GPS ...

Go to advanced search