Search found 16 matches

by Hrdbill
Thu Feb 16, 2017 2:35 pm
Forum: Sensor-related questions
Topic: Wheel speed sensor question.
Replies: 4
Views: 7621

Re: Wheel speed sensor question.

Any thoughts?
75mm circumference with 1 or 2 teeth.


Thank you.
by Hrdbill
Thu Feb 09, 2017 9:53 pm
Forum: Sensor-related questions
Topic: Wheel speed sensor question.
Replies: 4
Views: 7621

Re: Wheel speed sensor question.

Ok, thanks for your help. So in theory it would be possible to run an ABS ring with all but 1 (or two opposite) tooth/teeth removed? It is not needed for ABS/Traction control Is there a minimum target width for the tooth? As per your Knowledge base. Reference Target Dimensions Tooth Height: .200 in....
by Hrdbill
Tue Feb 07, 2017 10:25 pm
Forum: Sensor-related questions
Topic: Wheel speed sensor question.
Replies: 4
Views: 7621

Wheel speed sensor question.

Wheel speed sensor question.

I'm looking to record wheel speed.
Can this be done with a 75mm ABS ring on the driveshaft (I have a 26 and 48 tooth option available) or from what i've read, will this generate too many pulses per mile?

Kind regards,
Bill
by Hrdbill
Tue Jan 24, 2017 3:34 pm
Forum: General support questions
Topic: DL1 Sport / Dash 2 Display live data on PC
Replies: 7
Views: 5303

Re: DL1 Sport / Dash 2 Display live data on PC

A null modem cable has a nine pin connector at each end. Google will assist you more. Hi Peterguk and support. Please forgive my ignorance, however I'm struggling to see how the data can be viewed at the same time it's being transferred between DL1/Dash 2 without the use of a 'Y' splitter cable. (I...
by Hrdbill
Thu Jan 19, 2017 11:59 pm
Forum: Installation problems
Topic: DL1 Sport / Dash 2 Firmware update
Replies: 1
Views: 6466

DL1 Sport / Dash 2 Firmware update

Hi guys. I have only just got round to installing our RT Dash 2 (April 2013) and DL1 (June 2013). Can you confirm that a firmware update is needed and what the latest versions are please. Didn't want to go ahead unless needed, as per the instructions in the RT manual. P.S. Are there any updates that...
by Hrdbill
Wed Jan 18, 2017 4:28 pm
Forum: General support questions
Topic: DL1 Sport / Dash 2 Display live data on PC
Replies: 7
Views: 5303

Re: DL1 Sport / Dash 2 Display live data on PC

Hi Peterguk, thanks for your message. I've been researching this lately and understand that the null modem has 9 pins like that on the DL2/Dash2 connector. It was whether or not I need a lead like the one below, to enable me to both share the data between Dash/Logger and also with a Laptop screen ru...
by Hrdbill
Wed Jan 18, 2017 1:27 pm
Forum: Sensor-related questions
Topic: Oil Pressure sensor calibraion
Replies: 2
Views: 7187

Re: Oil Pressure sensor calibraion

That's brilliant, thank you Race Technology.
by Hrdbill
Tue Jan 17, 2017 4:46 pm
Forum: Sensor-related questions
Topic: Oil Pressure sensor calibraion
Replies: 2
Views: 7187

Oil Pressure sensor calibraion

Hi all, Any suggestions for how to obtain the basic voltages/calibration data required to setup an 'unknown' pressure sensor? I understand with a temperature sensor I'm able to connect power to the sensor, heat the sensor, then manually check the temperature with an external device and measure/recor...
by Hrdbill
Tue Jan 17, 2017 1:28 pm
Forum: General support questions
Topic: DL1 Sport / Dash 2 Display live data on PC
Replies: 7
Views: 5303

Re: DL1 Sport / Dash 2 Display live data on PC

Support, thank you for your help.

So to confirm, I will need to use my null modem cable (serial one end, USB the other) and run this through a Y splitter?

I can't see how else to both send data between DL1/Dash2 and the computer at the same time without a splitter.

Many thanks
by Hrdbill
Sun Jan 01, 2017 12:24 pm
Forum: General support questions
Topic: DL1 Sport / Dash 2 Display live data on PC
Replies: 7
Views: 5303

Re: DL1 Sport / Dash 2 Display live data on PC

This is the correct configuration I think ...?
Female into the DL1
Male into Dash 2
Male into PC Serial lead (at least the one I have)

12-db9-rs232-serial-splitter-cable-1-female-2-male-4.jpg
12-db9-rs232-serial-splitter-cable-1-female-2-male-4.jpg (20.16 KiB) Viewed 5302 times
by Hrdbill
Sun Jan 01, 2017 12:19 pm
Forum: General support questions
Topic: DL1 Sport / Dash 2 Display live data on PC
Replies: 7
Views: 5303

DL1 Sport / Dash 2 Display live data on PC

Hi guys, It's been a while since i've been on here, but now the project car is nearing it's wiring stage, I'm getting back into the swing of things. Is anyone able to advise me on the following. I have : DL1 Sport (8 analogue inputs) Dash 2 (4 analogue inputs) Laptop (USB - Serial lead) I understand...
by Hrdbill
Mon Jun 30, 2014 8:11 pm
Forum: Installation questions
Topic: Classic mini RPM input
Replies: 1
Views: 7052

Classic mini RPM input

Anyone have experience installing a dash 2 or DL1 sport into a classic car such as a mini?


I am trying to get some clarification about wiring the Rpm engine speed.

Many thank,
Bill
by Hrdbill
Mon Jun 30, 2014 8:09 pm
Forum: General support questions
Topic: Wireless telemetry
Replies: 6
Views: 6903

Would something like this be sufficient?

http://www.rfsolutions.co.uk/acatalog/info_ZULU_M868_SO.html
by Hrdbill
Thu Mar 06, 2014 6:11 pm
Forum: General support questions
Topic: Wireless telemetry
Replies: 6
Views: 6903

Anyone able to shed some light on this ? just curious, you know..

Thanks
by Hrdbill
Thu Mar 06, 2014 5:55 pm
Forum: General support questions
Topic: Wireless telemetry
Replies: 6
Views: 6903

Anyone able to shed some light on this ? just curious, you know..

Thanks

Go to advanced search