Search found 5 matches

by Red Seven
Sun May 24, 2020 2:05 pm
Forum: General software support
Topic: ...overlay sprint/hillclimb runs in 8.5
Replies: 5
Views: 12424

Re: ...overlay sprint/hillclimb runs in 8.5

Hi Red21, I see your overlays use a common "distance" axis. (where I'm trying to compare by time) How are you synchronising the start of the runs? (when do you start logging? I normally start logging whilst in a que to the start area, and manually trim, sometimes several minutes before my run actual...
by Red Seven
Fri May 22, 2020 10:47 am
Forum: General software support
Topic: ...overlay sprint/hillclimb runs in 8.5
Replies: 5
Views: 12424

Re: ...overlay sprint/hillclimb runs in 8.5

Hi, I don't see how the scratch pad would help? In release 8 and below, I can trim each separate run so that each separate run file starts at the instant that the car starts to move. I can then overlay run files in and XY graph as the attached screen shot. In release 8.5, run manage does not seem to...
by Red Seven
Wed May 20, 2020 2:05 pm
Forum: General software support
Topic: ...overlay sprint/hillclimb runs in 8.5
Replies: 5
Views: 12424

...overlay sprint/hillclimb runs in 8.5

I've struggled a few years ago to successfully overlay sprint/hillclimb runs over each other in release 8.5? I've been using my DL1 for over 10 years using up to release 8 analysis software, where I trim each run to start at the instant where the long.acc. starts to increase on the XY graph with the...
by Red Seven
Thu Oct 12, 2017 8:23 pm
Forum: General support questions
Topic: Arduino
Replies: 49
Views: 81945

Re: Arduino - thread resurection

Hi, 'bit of a thread resurrection. I'd like to build a device to read a couple of the analog inputs into my DL1 via RS232 into an Arduino, and then display four lines of text with four numeric values that have been manipulated in the arduino. Once I've got the values into the Arduino, I know I can m...
by Red Seven
Fri May 03, 2013 12:24 pm
Forum: General software support
Topic: Analysis 8.5.138 - XY graph default X units?
Replies: 1
Views: 5317

Analysis 8.5.138 - XY graph default X units?

Hi,
whenever I open the XY graph, the x axis defaults to "distance", but I'd prefer it to default to "time".
I'm using Analysis 8.5.138
Is it possible to save this preferance?
If so, how?

Go to advanced search