Search found 11 matches
- Sun Feb 26, 2012 5:49 pm
- Forum: General software support
- Topic: Data Alignment Issues
- Replies: 10
- Views: 26531
- Sun Feb 26, 2012 5:20 pm
- Forum: General software support
- Topic: Data Alignment Issues
- Replies: 10
- Views: 26531
That sounds like normal averages to me. That's what confuses me then if the positional data is reasonably accurate per that data, yet the distances items don't line up at all in the data. Off by much more than several meters. That said, if the 3-6M is normal I'm not sure that I will be able to see ...
- Sun Feb 19, 2012 4:17 am
- Forum: General software support
- Topic: Data Alignment Issues
- Replies: 10
- Views: 26531
- Sat Feb 18, 2012 4:31 pm
- Forum: General software support
- Topic: Data Alignment Issues
- Replies: 10
- Views: 26531
- Sat Feb 18, 2012 4:27 am
- Forum: General software support
- Topic: Data Alignment Issues
- Replies: 10
- Views: 26531
It sounds like the GPS data just isn't very good - I would suggest that you send a run file to the US office for him to look over. The most common reason is that the GPS antenna is starting to fail. Regards, Support I see this issue in the data back to day 1 of the equipment (about 2 years ago). We...
- Thu Feb 16, 2012 5:38 pm
- Forum: General software support
- Topic: Data Alignment Issues
- Replies: 10
- Views: 26531
Data Alignment Issues
I sent in a request to the US Support contact, but figure I may get additional points from some of the regulars on here. So minor apology for the two pronged push for information. I've been trying to do a lot of positional analysis of my autocross runs to see variances in turn in location and brakin...
- Sun Apr 24, 2011 2:39 pm
- Forum: General software support
- Topic: Variable comparison between two runs
- Replies: 8
- Views: 15196
- Fri Apr 22, 2011 3:32 pm
- Forum: General software support
- Topic: Variable comparison between two runs
- Replies: 8
- Views: 15196
I don't beleive you can create a formula that compares two runs if that's what you are trying to do. However, Analysis does allow you to set a 'base' lap against which a second set of data is compared (for time slip etc.). So you could choose a base lap from Run 1 (with driver 1) and compare with a...
- Thu Apr 21, 2011 6:09 pm
- Forum: General software support
- Topic: Variable comparison between two runs
- Replies: 8
- Views: 15196
- Thu Apr 21, 2011 4:32 pm
- Forum: General software support
- Topic: Variable comparison between two runs
- Replies: 8
- Views: 15196
Actually in the same car. I'll try creating the car file. I'm trying to do something other than just the graphs though. Rather than having to try to find the points and measure what the distance actually is from the graphs I want to try to report it out. Ideally what we plan to do is at the race aft...
- Thu Apr 21, 2011 12:42 pm
- Forum: General software support
- Topic: Variable comparison between two runs
- Replies: 8
- Views: 15196
Variable comparison between two runs
I posted this over on your vendor section at sccaforums.com so I apologize for the double post, but doesn't look like you guys stay too active over there. I'm trying to do some comparison on braking and acceleration between drivers in an autocross situation and I can't figure out how to create the i...