Having trouble adding track marker from the Dash 4. Status is okay and have GPS lock and logging, but when I hit the add track marker i get the error message Failure! GPS data missing Newest firmware on everything. Anyone have any clue how to fix this, been having trouble since I got the system.

Got another question. I've noticed that in situations where the wheel goes from say 40 mph to lockup in less than one rotation the sensor reads as if it's still at 60 mph until the wheel starts to turn again and updates. Is there anyway to make it so it has to have a constant signal otherwise it rea...

Okay, testing it out in the analysis software. if(var_0414/4-min(VAR_0300,VAR_0301)>2,1,0) works fine if I just use GPS speed minus minimum of front 2 wheels. Wheel frequency x 4 is MPH. but if(avg(VAR_0300,VAR_0301)-min(VAR_0300,VAR_0301)>2,1,0) is just outputting the average of the front 2 wheels....

[quote="Support"]Hello, I would do it like this... IF(IF(VAR_0407>2,avg(VAR_0300,VAR_0301,VAR_0302,VAR_0304),VAR_0414)-(min(VAR_0300,VAR_0301,VAR_0302,VAR_0304))>1,1,0) This is doing... IF(If GPS speed accuracy is more then 2 output the average wheel speeds.) - (minimun wheel speed of all ...

Trying to setup my system to turn on a light for brake lockup on the fronts and another on the rear. System is the mk3 I have 1 light setup on output driver 1 and another on 2. I figure I could just divide carspeed over wheelspeed and then if then have a trigger value of .5 or something. How do I se...

That was it, all good now.

I wired up my output drivers and they don't seem to be working, I found this line though and maybe I have them wired wrong. When the output is active the output pin is driven to ground, so the load must be connected between a supply and the pin, NOT between the output pin and ground. I have the outp...

Thanks, it worked

I have a Dl1 MK3 and trying to figure out how to display voltage. I figured I could just split off the power wire and run it into an analog input as well, but I noticed it said 12v max and it probably runs at 13-14. Would it still work? Any other way to display system voltage?

I live in the US. I've check pegasus, and a ridiculous amount of other places. I'm resorting to just tapping my own threads. The really need to get 1/8 npt sensors for us US folk.

Anyone, anyone? I can't be the only one who has ever bought a temp sensor from them.

Has anyone found a place that sells adapters or t fittings to plug the m12x1.5 temp sensors into?