Search found 8 matches
- Mon May 28, 2018 8:12 am
- Forum: General support questions
- Topic: Water temp erratic
- Replies: 2
- Views: 6882
Re: Water temp erratic
Thanks for the reply, engines had a few other issues on the dyno so i'll not be doing anything with it for few weeks, but will get in touch when I am. Thanks again.
- Tue May 22, 2018 10:29 pm
- Forum: General support questions
- Topic: Water temp erratic
- Replies: 2
- Views: 6882
Water temp erratic
Hi, had my dash2, video 4 and DL1 for years and its been great but since I reflashed my dash2 to utilise the new software my water temp has been bouncing about all over. When I first turn the dash on it reads correctly, then slowly drops down to 0, then climbs again to the correct temperature and dr...
- Thu Dec 09, 2010 12:14 am
- Forum: General support questions
- Topic: Video4 overlay
- Replies: 1
- Views: 4278
Video4 overlay
Just messing about with the video export wizard after the first time I have used my DL1, Dash2 and Video 4, and there is a section where you can add an overlay. Does this mean you can actually do the original recording without an overlay and then add it afterwards? Also, is it possible to alter the ...
- Fri Jun 04, 2010 12:42 pm
- Forum: General support questions
- Topic: RPM not working from ECU interface.
- Replies: 1
- Views: 4162
- Thu Jun 03, 2010 8:55 pm
- Forum: General support questions
- Topic: RPM not working from ECU interface.
- Replies: 1
- Views: 4162
RPM not working from ECU interface.
I have a DL1, Dash2 and Video4 with an ECU interface for a DTA S60, everything is working nicely except for the RPM which I cannot get to work at all. I have set everything up as it should be-main points been that RPM is disabled for storage and serial port as per the note in the configuration tool,...
- Tue Jun 01, 2010 10:25 pm
- Forum: Sensor-related questions
- Topic: steering angle
- Replies: 4
- Views: 8900
- Fri May 28, 2010 10:45 pm
- Forum: Sensor-related questions
- Topic: steering angle
- Replies: 4
- Views: 8900
Right, after reading the info on the link it seems I should have mentioned the sensor has 3 wires, a 5v ref, an output and a gnd. According to the link this means I can connect it directly to the DL1 analog inputs without a resistor, is this correct? I will also soon be fitting some brake pressure s...
- Wed May 26, 2010 11:32 pm
- Forum: Sensor-related questions
- Topic: steering angle
- Replies: 4
- Views: 8900
steering angle
I am currently in the process of wiring up a DL1, dash2 and video4 and need some help with sensors. I am using a steering angle sensor which was already fitted to the car. It is a potentiometer which increases it's resistance as you turn it, until a certain point whereby it returns to 0 ohms and sta...