I run a single seater, with the DL1 on two rubber AV bushes and I have to tape the CF card in with gaffer tape every run to avoid it coming out under acceleration.
hope that helps.
Steve
www.moleracing.com
Search found 8 matches
- Sun Jun 20, 2010 9:33 pm
- Forum: General support questions
- Topic: Holding in Memory Card on DL1
- Replies: 5
- Views: 8397
- Wed Mar 17, 2010 10:38 pm
- Forum: General software support
- Topic: Problem getting battery voltage to show on DASH2
- Replies: 5
- Views: 10258
- Wed Mar 17, 2010 10:35 pm
- Forum: Installation questions
- Topic: RPM readout non existent - any suggestions please
- Replies: 1
- Views: 5509
RPM readout non existent - any suggestions please
All is now working on my new mk2DL1 and Dash2 installation in race car apart from the RPM.
I have used the old signal that fed the tacho. I get 0 rpm when the engine is idling at 1100rpm.
Can anyone sugest a few pointers as to what I've done wrong
many thanks
Steve
I have used the old signal that fed the tacho. I get 0 rpm when the engine is idling at 1100rpm.
Can anyone sugest a few pointers as to what I've done wrong
many thanks
Steve
- Wed Mar 17, 2010 7:22 pm
- Forum: Installation questions
- Topic: Problem getting battery voltage to display on Dash 2
- Replies: 3
- Views: 7552
Solved!
All I did was swap the battery voltage to input 6 as opposed to 8. Made a y=x equation and set up the dash screen.
Strangely I did this all on input 8 and it didnt work?
Anyway, all OK, just the rpm to get running now!
- Tue Mar 16, 2010 7:36 am
- Forum: Installation questions
- Topic: Problem getting battery voltage to display on Dash 2
- Replies: 3
- Views: 7552
Thanks Osborni, I have all the other inputs (water, oil and throttle working OK into the DL1 and via the serial to the dash 2, and the dash.dot file works OK, ie I can minipulate equations and change screens etc on the CF card and make the Dash2 respond correctly. So I think I've done that OK. I jus...
- Mon Mar 15, 2010 10:34 pm
- Forum: General software support
- Topic: Problem getting battery voltage to show on DASH2
- Replies: 5
- Views: 10258
- Mon Mar 15, 2010 4:21 pm
- Forum: Installation questions
- Topic: Problem getting battery voltage to display on Dash 2
- Replies: 3
- Views: 7552
Problem getting battery voltage to display on Dash 2
Hi, I have consulted the forum and foun dtwo similar topics and followed advise but still cannot get the battery voltage to display. This is what I have done and tried a number of variations around this. Take the voltage (12.63V) and feed into the analogue input on the DL1, Ive used Analogue 8 but t...
- Sat Mar 13, 2010 7:18 am
- Forum: General software support
- Topic: Problem getting battery voltage to show on DASH2
- Replies: 5
- Views: 10258
battery voltage display problem
Any answers please RT? I have the same issue