Search found 4 matches
- Sun May 15, 2011 6:48 am
- Forum: General support questions
- Topic: DASH3 AND DL1 MK2 PROBLEMS
- Replies: 3
- Views: 6516
I use new 2Gb card and where formateated before put inside DL1 configuration. I flash DL1, Dash3 and Can Converter with last fimwares and I installed last analysis software. I put an insolation to protect DL1 from vibrations and temperature from exhaust. Is installed in rear part of a motorcycle. Af...
- Fri May 13, 2011 7:07 am
- Forum: General support questions
- Topic: DASH3 AND DL1 MK2 PROBLEMS
- Replies: 3
- Views: 6516
DASH3 AND DL1 MK2 PROBLEMS
For second time I go to a track day and I lose a lot of precious information because does not run proper... First time was for a "problem" on card memory. I don't know why, memory fall down. This last day, dash3 does not show times... I mark correctly start point and seams to be all fine, ...
- Wed Nov 10, 2010 2:41 pm
- Forum: General support questions
- Topic: dl1 destroy flash card.......
- Replies: 3
- Views: 6254
- Tue Sep 29, 2009 12:35 pm
- Forum: General software support
- Topic: AFR TABLE
- Replies: 0
- Views: 25221
AFR TABLE
Is possible to make an AFR table with x rpm values and y tps values or kPa values for ecu adjust? I'll need to manually put rps and tps values to has same values as racing Ecu to make AFR corrections. In my ecu I can configure when uses TPS or IAP values so if I defined than ecu uses Iap values when...