Search found 7 matches
- Wed Jun 01, 2022 12:43 pm
- Forum: General support questions
- Topic: FIRMWARE: DL1 Mk2 & Dash3Pro
- Replies: 4
- Views: 28932
Re: FIRMWARE: DL1 Mk2 & Dash3Pro
I would imagine the firmware is part of the the old legacy software (v8.5), the download is at the bottom of the linked page below https://www.race-technology.com/gb/racing/software-downloads Information on reflashing is here https://www.race-technology.com/wiki/index.php/Reflashing/ReflashingDataLo...
- Wed Apr 06, 2022 4:28 pm
- Forum: General software support
- Topic: DASH-2Pro Can-bus to Haltech
- Replies: 2
- Views: 10907
Re: DASH-2Pro Can-bus to Haltech
I see no reason why that shouldn't work, the Dash2 Pro has 2 CAN ports available for use, and there are references to the Haltech ECU's via CAN in the knowledge base, either by using a ECU interface or the by direct CAN through the H/L wires, both require a purchase of some kind, whether that is the...
- Wed Apr 06, 2022 4:05 pm
- Forum: Sensor-related questions
- Topic: oil pressure incorrect reading please help
- Replies: 11
- Views: 74776
Re: oil pressure incorrect reading please help
What other problems are you having, not sure I can help much, but happy to give it a go ? I've was in the same situation for weeks trying to figure stuff out, and Support from RT is not very forthcoming at the best of times I'm afraid, even direct support is slow, so if you want an answer be prepare...
- Tue Apr 05, 2022 11:48 am
- Forum: Installation questions
- Topic: DL1 Club auto record GoPro and charging issue
- Replies: 0
- Views: 252425
DL1 Club auto record GoPro and charging issue
Hi, I've wired up and configured my DL1 Club to auto record my GoPro Hero 3 (using one button mod) through a wired cable to the 30 pin BUS connector, this by itself works perfectly when the logging is enabled by the external remote button I also configured. Whilst I was making the cable I also wired...
- Thu Mar 31, 2022 4:11 pm
- Forum: General support questions
- Topic: Dl1 sport logging status
- Replies: 2
- Views: 24273
- Thu Mar 31, 2022 3:50 pm
- Forum: Sensor-related questions
- Topic: oil pressure incorrect reading please help
- Replies: 11
- Views: 74776
Re: oil pressure incorrect reading please help
You need a calibration map to setup the sensor, ideally you would get that from the sensor manufacture, but I can't see one anywhere for that sensor. You can map them yourself with a handheld pressure tester, but that extra expense for a single use? meh! Just as well purchase a new sensor with a pub...
- Thu Mar 24, 2022 10:56 am
- Forum: Sensor-related questions
- Topic: Oil pressure in psi, water temp sensor with single wire
- Replies: 5
- Views: 34055
Re: Oil pressure in psi, water temp sensor with single wire
I think this thread from another forum will help you understand it better, you have to create a calibration map for the sensor readings at various temperatures recoding the ohms, you can then translate that along with you reference voltage and pull-up into the correct voltage values using the volts ...